Value Collection 06811251 Compression Spring 0.36in Od

Product Description

The VALUE COLLECTION 06811251 is a helical compression spring designed for light-duty mechanical and industrial applications. With an outside diameter of 0.36 inches and a free length of 1.5 inches, this spring delivers a maximum work load of 4.5 pounds and a spring rate of 4.3 pounds per inch. Wire diameter measures 0.032 inches, and the solid height is 0.358 inches. This spring is suited for use in assemblies, fixtures, valves, latches, and other mechanisms requiring consistent compressive return force. Maintenance technicians, machine builders, and mechanical contractors install these springs in a wide range of light-load applications across HVAC, plumbing, and general mechanical equipment.

This spring fits applications where the mating hole diameter is 0.375 inches or smaller. Its compact free length and low spring rate make it appropriate for valves, push-button mechanisms, damper actuators, and similar assemblies found in both residential and light commercial equipment. Sold in a pack of 10, this spring suits both single-unit repairs and small-batch assembly work. The minimum order quantity is 1 pack of 10 units.

Key Features

• 0.36 inch outside diameter fits standard 0.375 inch hole diameters
• 1.5 inch free length with a solid height of 0.358 inches
• 4.3 pounds per inch spring rate for controlled, consistent compression
• Maximum work load of 4.5 pounds for light-duty mechanical applications
• 0.032 inch wire diameter for fine-pitch coil construction
• Sold in a pack of 10 for repair stock or assembly use

Compatibility

Designed as a general-purpose compression spring suitable for light mechanical assemblies, valves, latches, fixtures, and similar applications requiring a 0.36 inch OD and 1.5 inch free length specification.

Installation Notes

Compression springs should be installed by a qualified technician familiar with the host assembly. Always de-energize and depressurize the system before disassembling any spring-loaded component. Confirm that the mating bore and seat dimensions match the spring OD and solid height before installation. Avoid over-compressing beyond the rated maximum work load, as this can cause permanent set and reduce spring performance.