Pilot Assemblies

Customer Support Image

Need Support?

Call Jack and His Team

What Are Pilot Assemblies?

Pilot assemblies are small but vital components in gas-powered appliances. They provide the initial flame that ignites the main burner, ensuring your system starts safely and reliably.

Water Heater Pilot Assembly

A water heater pilot assembly maintains a constant flame to ignite the burner when hot water is needed. A properly working assembly is key to consistent water heating.

Gas Pilot Assembly Function

The gas pilot assembly controls the flow of gas to the pilot flame. It works with thermocouples or ignition systems to maintain safety and ensure proper combustion.

Common Pilot Assembly Parts

Typical pilot assembly parts include the pilot burner, thermocouple, tubing, and brackets. These parts must be in good condition to ensure proper ignition and prevent gas leaks.

When to Replace a Pilot Assembly

If your appliance struggles to ignite or the flame goes out frequently, the pilot assembly may be dirty or damaged. Replacing it can restore safe, efficient operation.

Choosing the Right Assembly

Not all pilot assemblies are the same. Choosing the correct model for your system ensures compatibility and long-term performance.

Frequently Asked Questions

Typically located near the bottom of a gas appliance (water heater or furnace) behind the burner access panel. You’ll see the pilot tube, thermocouple sensor, and ignitor near the burner port.

Common causes include:

  • Thermocouple wear causing pilot to go out.
  • Clogged pilot tube or orifice causing weak flame.
  • Drafts blowing the flame out.
  • Dirty ignitor or pilot tip affecting ignition or stability.

  • Pilot flame is yellow, weak, or unsteady.
  • Pilot won’t stay lit, even after cleaning.
  • Thermocouple fails to hold gas valve open.
  • Repeated relighting or trips in gas flow.

If cleaning doesn’t fix it, you’ll often need to replace the entire pilot assembly, not just individual parts.

Yes, if:

  • The pilot orifice is just clogged – clean with compressed air or needle.
  • The thermocouple or ignitor is accessible and compatible. Be sure to turn off gas and wait before working.
  • However, for electronic pilots or if gas valve is integrated, it's safer to fit a complete OEM assembly or call a technician.
  • Clean or inspect annually to remove dirt/soot.
  • Replace every 8–10 years, or if symptoms recur frequently.
  • If the thermocouple fails repeatedly, full assembly replacement is recommended.

If the water heater or furnace is <10 years old and in good condition, replacing the pilot assembly is typically cost-effective. For older units (>10 years) with repeated failures, consider full appliance replacement instead.