Pryor TI050 E Hardened Steel Type Letter E 3/16 Inch

Product Description

The PRYOR TI050 E is an individual hardened steel type character used for cold stamping the letter E onto metal, plastic, and other hard surfaces. At 3/16 inch character height, this single type piece is part of a modular stamping system that allows tradespeople, machinists, and fabricators to mark parts, assemblies, tooling, and components with permanent, legible identification. The hardened steel construction provides the durability needed for repetitive impact use without deforming the face of the character. It weighs 0.222 pounds and ships as a single unit.

This type character is suited for industrial and trade applications where permanent part marking is required. Common use cases include stamping serial numbers, inspection marks, or assembly codes onto metal components in fabrication shops, HVAC equipment manufacturing, plumbing rough-in assemblies, and electrical panel labeling. The 3/16 inch size is a widely used standard for general industrial marking work where legibility and compact character size are both required.

Key Features

• Hardened steel construction resists deformation under repeated hammer or press impact
• 3/16 inch character height suits general-purpose industrial part marking
• Individual type piece allows custom character selection without purchasing a full set
• Compact and lightweight at 0.222 pounds for easy handling and storage
• Compatible with standard type holder and stamp guide systems

Compatibility

Designed as an individual replacement or supplemental character for use with standard modular steel type stamping sets and holders that accept 3/16 inch type pieces.

Installation Notes

Stamping type characters should be installed by machinists, fabricators, or qualified tradespeople familiar with manual or press-assisted marking operations. Secure the type piece firmly in a holder or guide before striking to ensure a clean, straight impression. Use appropriate personal protective equipment including eye protection when operating stamping tools. Do not strike the type piece at an angle, as this can damage the character face or cause uneven marking.