Kennametal 7096312 Carbide Profiling Insert KCU10B Altin

Product Description

The KENNAMETAL 7096312 is a carbide profiling insert designed for precision turning and grooving operations on CNC lathes and turning centers. Built to ISO code KCGX110302R15, this right-hand insert carries a KCU10B manufacturer grade and features an AlTiN coating applied via PVD process for improved wear resistance and thermal stability at elevated cutting speeds. At 0.125 inches thick with a 0.20 mm corner radius and an included angle of 11 degrees, it is engineered for tight-tolerance profiling passes in ferrous and non-ferrous materials. Machinists and CNC operators working in production turning environments install this insert as a direct replacement in compatible clamp-style toolholders.

This insert suits production and job-shop turning applications where consistent surface finish and accurate profile geometry are required. The NPR/L insert style and insert size code 505 make it a fit for narrow grooving and profiling operations on external diameters. Its 0.125-inch maximum depth of cut keeps it well-suited for finish passes and light profiling cuts rather than heavy roughing. CNC machinists and tool-and-die professionals typically select this insert for applications demanding fine corner geometry and controlled chip formation.

Key Features

• Carbide substrate with AlTiN PVD coating for extended tool life at high cutting speeds
• KCU10B grade delivers hardness and toughness balance for profiling operations
• 0.20 mm corner radius for precise profile geometry and surface finish control
• Right-hand cutting orientation with clamp insert holding method
• Two cutting edges per insert for extended service before changeover
• ISO code KCGX110302R15 for straightforward cross-referencing and toolholder matching

Compatibility

Designed for use in clamp-style toolholders accepting NPR/L style inserts with insert size code 505 and ISO designation KCGX110302R15. Verify toolholder pocket geometry and seating requirements before installation.

Installation Notes

Installation is performed by qualified CNC machinists or tool-setup personnel. Power down and lock out the machine spindle before seating or replacing inserts. Use the appropriate torx or hex key as specified by the toolholder manufacturer when tightening the clamp screw - do not overtighten. Inspect the toolholder pocket for chips or debris before seating the insert to ensure proper registration and prevent premature edge failure.