Kennametal 1015980 DA200 Double Angle Reamer Collet Chuck

Product Description

The KENNAMETAL 1015980 is a DA200 Double Angle Reamer Collet Chuck designed for holding reamer tooling in machining operations that require controlled float and precise alignment. Built with a 3/4 inch straight shank, this chuck provides a 1.6 inch projection and accepts collets ranging from 1/64 inch to 3/8 inch capacity. The double angle collet system allows for a float from center of 0.004 inch, which compensates for minor misalignment between the spindle and the workpiece hole. This chuck is installed by machinists and toolroom technicians working with vertical and horizontal machining centers or drill presses.

This collet chuck is suited for reaming operations in production and job shop environments where hole sizing accuracy and surface finish are critical. The straight shank configuration makes it compatible with standard machine spindles and tool holders that accept 3/4 inch shank tooling. It is typically used in applications involving ferrous and non-ferrous materials where the DA200 collet system is already in use or specified by engineering.

Key Features

• Double angle reamer collet system with 0.004 inch float from center for misalignment compensation
• 3/4 inch straight shank for direct spindle or holder mounting
• 1.6 inch projection for standard reach in reaming applications
• Collet capacity range of 1/64 inch to 3/8 inch accommodates a wide range of reamer shank sizes
• DA200 collet system compatibility for use with existing DA200 collet inventories

Compatibility

Designed for use with the DA200 double angle reamer collet system. Compatible with machine spindles and tool holders accepting a 3/4 inch straight shank. Specific machine model compatibility should be verified against spindle bore and shank tolerance specifications prior to installation.

Installation Notes

Installation should be performed by a qualified machinist or toolroom technician. Power down and lock out the machine spindle before mounting or removing the collet chuck. Use the appropriate collet wrench or spanner for the DA200 system to seat and torque the collet nut — do not use pipe wrenches or improvised tools that may damage the collet seating surfaces. Verify runout with a dial indicator after installation before beginning any reaming operation.