Kennametal 1013502 Double Angle Reamer Collet Chuck

Product Description

The KENNAMETAL 1013502 is a DA180 double angle reamer collet chuck designed for precision reaming operations on CNC machining centers and manual milling machines. It accepts a straight shank interface at 2 inches and provides 2.88 inches of projection from the spindle face. The collet capacity ranges from 1/32 inch to 3/4 inch, accommodating a wide range of reamer shank diameters. Through-coolant capability delivers cutting fluid directly to the tool tip, supporting tool life and chip evacuation in deep-bore reaming applications. Licensed machinists and CNC setup technicians are the primary installers of this toolholder.

This collet chuck is suited for production machining environments where consistent bore sizing and fine surface finish are required. The DA180 double angle collet system provides radial float, which allows the reamer to self-center in a previously drilled or bored hole. A locknut diameter of 2.38 inches and a float-from-center value of 0.10 inch support controlled floating action during the reaming pass. It is appropriate for use in both ferrous and non-ferrous material applications where reamer runout and alignment must be tightly managed.

Key Features

• DA180 double angle collet system with 0.10 inch radial float from center
• 2 inch straight shank for direct spindle or adapter mounting
• 2.88 inch projection from spindle face for reach into recessed bores
• Collet capacity from 1/32 inch to 3/4 inch covers a broad range of reamer shanks
• Through-coolant design channels fluid to the cutting zone for improved tool life and chip removal
• Locknut diameter of 2.38 inches provides secure collet retention under cutting loads

Compatibility

Designed for use with DA180 series double angle reamer collets. Confirm spindle interface and projection requirements against your specific machine tool setup before ordering.

Installation Notes

Installation is performed by qualified machinists or CNC tooling technicians. Power down and lock out the machine spindle before mounting or removing any toolholder. Ensure the shank bore and toolholder shank are clean and free of chips or burrs before seating. Verify through-coolant port alignment with the machine spindle coolant supply before commencing a cutting cycle.