Irwin IWAF34614 Magnetic Nutsetter 1/4 Inch Hex 6 Inch

Product Description

The IRWIN IWAF34614 is a magnetic nutsetter bit designed for use with power screwdrivers, impact drivers, and hex-chuck drill drivers. It features a 1/4 inch hex drive shank and measures 6 inches in overall length, making it well-suited for driving fasteners in confined or deep-access locations where a standard-length bit falls short. The integrated magnetic tip retains nuts and hex-head fasteners during placement, reducing drops and improving single-handed workflow. This bit is commonly used by HVAC technicians, electricians, plumbers, and general trade contractors when assembling panels, enclosures, duct work, and electrical boxes.

This nutsetter fits into standard 1/4 inch hex quick-change chucks found on most cordless and corded power drivers. The 6 inch length adds reach for recessed fasteners without requiring an extension. It is a practical addition to any service van or job-site tool kit where hex-head sheet metal screws, machine screws, or nuts are driven regularly. Packaged as a single bit, it is easy to stock individually or alongside other hex accessories.

Key Features

• 1/4 inch hex drive shank fits standard quick-change chucks
• 6 inch overall length provides extended reach into recessed areas
• Magnetic tip retains nuts and hex-head fasteners during installation
• Compatible with cordless drills, impact drivers, and power screwdrivers
• Lightweight at 0.1 pounds for reduced fatigue during repetitive driving tasks

Compatibility

Designed for use with any power driver or drill equipped with a standard 1/4 inch hex quick-change chuck. Suitable for driving hex-head sheet metal screws, machine screws, and similarly sized nuts in HVAC, electrical, and plumbing applications.

Installation Notes

Insert the 1/4 inch hex shank fully into the quick-change chuck until it locks before operating. When using with an impact driver, confirm the bit is rated for impact use to avoid premature breakage. Keep the magnetic tip clear of ferrous debris that could interfere with fastener seating. No special tools or trade license is required to use this accessory, though NEC and other applicable codes still govern the work being performed.