Io Hvac Controls TD-0806 Rectangular Zone Damper 8x6 in

Product Description

The IO HVAC CONTROLS TD-0806 is a rectangular zone damper designed for residential and light commercial HVAC zoning systems. It controls airflow to individual zones within a ducted forced-air system, allowing independent temperature management across different areas of a building. The damper ships with a 60-second Belimo 3-wire actuator pre-installed, delivering reliable, controlled blade movement without the need for a separate actuator purchase. The duct opening size is 8 inches wide by 6 inches tall. Licensed HVAC technicians typically install this damper as part of a zoning control system alongside a compatible zone control board and thermostat wiring.

This damper is intended for use in Trane and American Standard ducted forced-air systems requiring rectangular zone dampers. It fits within standard rectangular duct runs where zone control is being added or replaced. The 3-wire Belimo actuator is compatible with most zone control boards that output a standard open/close 24-volt signal. Typical applications include residential multi-zone systems, light commercial retrofits, and new construction zoning installations where Trane or American Standard equipment is specified.

Key Features

• 8 inch by 6 inch rectangular duct opening for direct duct installation
• 60-second Belimo 3-wire actuator included for precise, timed blade actuation
• Designed for compatibility with Trane and American Standard zoning applications
• 3-wire actuator wiring supports standard open, close, and common control configurations
• Package dimensions of 10 inches wide by 17 inches tall by 8 inches deep for storage and shipping planning

Compatibility

Designed for use with Trane and American Standard rectangular duct zoning systems requiring an 8 inch by 6 inch damper with a 60-second Belimo 3-wire actuator.

Installation Notes

Installation should be performed by a licensed HVAC technician familiar with low-voltage zoning controls and duct modification work. Power down the air handler and de-energize all low-voltage control wiring before cutting into the duct or connecting actuator leads. Follow the zone control board manufacturer wiring diagram when connecting the 3-wire actuator. Local mechanical codes and manufacturer guidelines should govern duct sealing and sheet metal work at the damper installation point.