Hexarmor 3013IMP-XL (10) Cut Resistant Impact Gloves A6

Product Description

The HEXARMOR 3013IMP-XL (10) is a coated, cut- and puncture-resistant work glove rated ANSI/ISEA Cut Resistance Level A6 and Puncture Resistance Level 4. Built on an 18-gauge HPPE shell with a polyurethane coating across the palm and fingertips, this glove delivers durable grip and dexterity in demanding trade environments. TPR back material adds impact protection where it matters most. At 0.431 pounds per pair, the glove is sized X-Large and runs 10 inches in overall length. It is designed for trade professionals who work around sharp edges, puncture hazards, and impact risk simultaneously.

This glove suits residential and commercial jobsite applications where multi-hazard hand protection is required. Typical use cases include HVAC sheet metal handling, pipe fitting, electrical work near sharp conduit edges, and general mechanical assembly. The textured grip surface supports tool handling in both dry and light-contact conditions. The knit cuff style allows easy donning and removal during frequent task changes. The high-visibility yellow and gray colorway improves worker visibility on busy job sites.

Key Features

• ANSI/ISEA Cut Resistance Level A6 for protection against high-risk sharp edges
• ANSI/ISEA Puncture Resistance Level 4 HPPE shell construction
• ANSI/ISEA Abrasion Resistance Level 3 for extended glove life
• Polyurethane coating on palm and fingertips for secure, textured grip
• TPR back material provides impact resistance across the hand dorsum
• 18-gauge HPPE liner balances cut protection with tactile sensitivity
• Knit cuff style and unisex sizing for broad fit compatibility

Compatibility

Designed as an OEM-style replacement or direct-use hand protection solution for trade professionals requiring ANSI/ISEA A6 cut resistance in X-Large sizing.

Installation Notes

Worn hand protection requires inspection before each use; discard gloves that show cuts, tears, or coating separation. These gloves are intended for dry to light-contact work surfaces; verify suitability for the specific hazard before use on chemical or wet applications. No tools or codes apply to donning, but always follow site-specific PPE requirements and OSHA hand protection standards for the task at hand.