Gws 314843 Square End Mill 1/2 in 3 Flute Solid Carbide

Product Description

The GWS 314843 is a solid carbide square end mill designed for precision material removal in ferrous and non-ferrous milling applications. It features a 0.5 inch mill diameter, a 1.25 inch length of cut, and three right-hand flutes with a 37-degree helix angle. Manufactured from submicron-grade solid carbide, this single-end tool delivers consistent edge retention and dimensional stability under demanding cutting conditions. The bright uncoated finish makes it well suited for materials where coating adhesion is a concern or where a clean, sharp edge is preferred. Licensed machinists and CNC programmers working in job shops or production environments are the primary users.

This end mill is intended for milling operations requiring a 0.5 inch shank diameter and a 3 inch overall length. The 1.25 inch length of cut accommodates moderate-depth slotting, profiling, and contouring passes. The right-hand cutting and right-hand flute direction configuration is standard for conventional CNC machining centers and manual knee mills. The centercutting capability allows for plunge entry without a pre-drilled pilot hole. Series 2030 positioning places this tool in GWS general-purpose solid carbide end mill offerings.

Key Features

• Submicron solid carbide construction for extended tool life and edge retention
• 37-degree helix angle promotes efficient chip evacuation and smooth cutting action
• Centercutting design allows direct plunge entry into workpiece material
• Right-hand cut and right-hand flute direction suits standard CNC spindle rotation
• Bright uncoated finish ideal for applications where coatings are not preferred
• Three-flute geometry balances chip clearance with surface finish quality

Compatibility

Designed as a standard 0.5 inch shank square end mill compatible with any CNC machining center, vertical mill, or manual knee mill equipped with an ER, TG, or equivalent collet chuck accepting a 0.5 inch shank diameter.

Installation Notes

Installation should be performed by a qualified machinist or CNC operator. Ensure the machine spindle is fully stopped and the tool-change mode is engaged before seating or removing the end mill from the tool holder. Confirm the shank is fully inserted to the recommended engagement depth in the collet or chuck before tightening to the holder manufacturer's specified torque. Inspect cutting edges for chips or wear before each use and replace the tool if edge damage is observed.