Frigidaire 137353303 Washer Door Lock Oem Part

Product Description

The FRIGIDAIRE 137353303 is an OEM door lock assembly designed as a direct replacement for front-load washing machines. This component secures the washer door during the wash and spin cycles, preventing the door from opening while the drum is in motion. The lock engages and releases under low-voltage control signals from the main control board. Licensed appliance technicians and experienced service professionals typically handle this replacement. At 0.98 inches x 0.98 inches x 0.98 inches, it is a compact assembly that fits within the door latch pocket of compatible units.

This door lock is intended for residential front-load washing machines manufactured under the Frigidaire and Electrolux brand families. Frigidaire and Electrolux are interchangeable names for the same brand, so units carrying either nameplate may use this part. It is suited for machines where the existing door lock has failed to engage, failed to release, or has caused fault codes related to door latch sensing. Installers working in residential laundry rooms will find this a straightforward like-for-like swap.

Key Features

• OEM authorized replacement part - not an aftermarket substitute
• Compatible with both Frigidaire-branded and Electrolux-branded units
• Compact form factor at 0.98 inches x 0.98 inches x 0.98 inches for easy fitment
• Direct-fit design requires no modification to the door latch pocket
• Resolves door latch faults and door-open error codes on compatible washers

Compatibility

Electrolux and Frigidaire are interchangeable names for the same brand, and units carrying either nameplate are covered by this OEM part. Designed as an OEM-style replacement for residential front-load washing machine door lock assemblies.

Installation Notes

A licensed appliance technician should perform this replacement. Before beginning, disconnect the washing machine from its power source and allow any residual drum motion to stop completely. The door lock assembly is typically secured by mounting tabs or screws accessible from inside the door boot seal area - refer to the unit service manual for the correct disassembly sequence. Reconnect power only after all wiring harness connectors are fully seated and the door boot seal is reinstalled.