Emtek 86636US4 Westridge Cabinet Pull Satin Brass

Product Description

The EMTEK 86636US4 is the Westridge Cabinet Pull finished in Satin Brass, designed for cabinet doors and drawers in residential and light commercial interiors. This pull features a 6 inch center-to-center hole spacing, making it a straightforward replacement or upgrade for standard cabinet hardware layouts. At 8.4 inches in overall length and 0.4 pounds, it provides a solid, substantial feel without excessive bulk. Finish is Satin Brass (US4), a warm, low-sheen tone suited to traditional, transitional, and contemporary millwork. Installers include finish carpenters, cabinetmakers, and general contractors handling interior trim packages.

The Westridge Cabinet Pull is intended for use on kitchen cabinets, bathroom vanities, built-in furniture, and millwork casework. Its 6 inch center-to-center spacing fits standard pre-drilled cabinet door and drawer fronts requiring that hole pattern. The Satin Brass finish coordinates with other US4-finished hardware in the same product line, allowing consistent hardware specification across a room or project. This pull is sold individually and is suited for both new installation and retrofit applications where the existing hole spacing matches.

Key Features

• 6 inch center-to-center hole spacing fits standard cabinet boring patterns
• Satin Brass (US4) finish — warm, low-sheen tone for traditional and transitional interiors
• Overall length of 8.4 inches with a width of 2.5 inches
• Lightweight at 0.4 pounds, suitable for frequent-use cabinet applications
• Sold as individual unit for flexible project quantities

Compatibility

Designed as an OEM-style replacement or new-installation pull for cabinet doors and drawer fronts with a 6 inch center-to-center hole spacing.

Installation Notes

Installation is typically performed by finish carpenters or cabinetmakers using a drill, screwdriver, and a template or jig to ensure accurate hole placement. Power down any adjacent electrical components before drilling near wiring runs inside cabinetry. Use the mounting screws appropriate for the cabinet door or drawer front thickness to avoid backing out under load. Confirm hole spacing with a template before drilling to prevent misalignment on finished surfaces.