Elements A500-3SN Cabinet Tab Pull 3 in Satin Nickel

Product Description

The ELEMENTS A500-3SN is a cabinet tab pull finished in satin nickel, designed for use on cabinet doors and drawers in residential and light commercial millwork applications. With a 3-inch overall length and a 60 mm (approximately 2.36 inches) center-to-center hole spacing, this pull fits standard cabinet boring patterns used across most cabinet lines. The satin nickel finish delivers a brushed, low-sheen appearance suited for contemporary and transitional cabinetry styles. Cabinet installers, finish carpenters, and remodelers install this hardware during cabinet installation or as a retrofit upgrade to existing cabinetry.

This tab pull is part of the Edgefield Collection by ELEMENTS and is appropriate for residential kitchen, bath, and furniture cabinetry as well as light commercial millwork. The tab-style profile sits close to the cabinet face, making it a practical choice in high-traffic areas where a low-projection pull is preferred. The 60 mm center-to-center spacing is a widely used standard dimension that aligns with pre-bored cabinet doors and drawer fronts from most major cabinet manufacturers.

Key Features

• 3-inch overall length fits standard cabinet door and drawer boring patterns
• 60 mm center-to-center hole spacing matches common pre-bored cabinet layouts
• Satin nickel finish provides a brushed, low-sheen surface resistant to fingerprints
• Tab-style profile with 1.5-inch projection keeps pull close to the cabinet face
• Part of the Edgefield Collection for coordinated hardware across a project
• 11/16-inch width suits narrow stile and standard-face-frame cabinet applications

Compatibility

Designed as a direct-fit replacement or new-installation tab pull for cabinet doors and drawer fronts with 60 mm center-to-center hole boring. Compatible with standard cabinet hardware mounting configurations used in residential and light commercial cabinetry.

Installation Notes

Cabinet tab pulls of this type are installed by finish carpenters, cabinet installers, or experienced DIYers using a screwdriver or drill driver. Verify that the mounting hole spacing on the cabinet door or drawer front matches the 60 mm center-to-center dimension before drilling new holes. When retrofitting, use a cabinet hardware jig to ensure consistent placement across all doors and drawer fronts. No special tools or trade licensing are required for standard cabinet hardware installation.