Elements 988-128BNBDL Cabinet Pull 128mm Brushed Pewter

Product Description

The ELEMENTS 988-128BNBDL is a cabinet pull finished in Brushed Pewter, part of the Zachary Collection. It measures 5.75 inches in overall length with a 128 mm (approximately 5.04 inches) center-to-center hole spacing, a width of 0.5 inches, and a projection of 1.25 inches. This pull is a hardware replacement or new-installation component suited for cabinet doors and drawers in residential and light commercial millwork applications. Installers in cabinetry, finish carpentry, and general contracting trades work with this type of hardware during kitchen, bath, and casework projects.

The 988-128BNBDL fits cabinet faces requiring a 128 mm hole spread, a common industry-standard spacing found on kitchen cabinets, bathroom vanities, and furniture-grade casework. The Brushed Pewter finish provides a muted, low-sheen metallic appearance suited to transitional and traditional design schemes. It is appropriate for both new construction installs and retrofit replacements where the existing hole pattern matches the 128 mm center-to-center dimension.

Key Features

• 128 mm center-to-center hole spacing — matches a widely used industry-standard cabinet drilling pattern
• 5.75 inches overall length provides a substantial grip surface relative to the hole spread
• Brushed Pewter finish delivers a matte, textured metallic look resistant to obvious fingerprinting
• 1.25 inch projection keeps the pull accessible and ergonomic for drawer and door operation
• 0.5 inch width presents a slim profile consistent with bar-pull style hardware
• Part of the Zachary Collection for finish and style coordination across a cabinet run

Compatibility

Designed as a direct-fit replacement or new-install pull for cabinet doors and drawers with a 128 mm center-to-center hole pattern.

Installation Notes

Cabinet pulls of this type are installed by finish carpenters, cabinetry professionals, or experienced DIYers using a drill, a cabinet hardware jig, and a screwdriver or bit driver. Mounting screws are typically not included and must be selected to match the cabinet door or drawer face thickness. Verify the existing or planned hole spacing matches 128 mm before drilling. Avoid overtightening fasteners, which can crack face frames or drawer fronts on thinner stock.