Elements 625-448MS Cabinet Bar Pull Matte Silver Square

Product Description

The ELEMENTS 625-448MS is a square cabinet bar pull finished in matte silver, designed for cabinet and drawer hardware applications. With a 448mm (approximately 17.6 inches) center-to-center hole spacing and an overall length of approximately 18 inches, this pull fits standard cabinet layouts without modification. The square profile and matte silver finish give it a clean, contemporary look suited to residential and light commercial millwork. Licensed tradespeople and finish carpenters handling cabinet hardware installations will find this pull straightforward to fit using common hand tools.

This bar pull is part of the Stanton collection and is intended for use on cabinet doors and drawers in residential kitchens, bathrooms, and built-in cabinetry. It is also appropriate for light commercial casework installations where a consistent, modern aesthetic is required. The 448mm center-to-center dimension corresponds to a common European cabinet hardware spacing, making it a practical fit for many standard frameless and face-frame cabinet configurations.

Key Features

• 448mm center-to-center hole spacing for standard European cabinet layouts
• Overall length of approximately 18 inches
• Square profile at 3/8 inch width for a clean, modern appearance
• 1-1/8 inch projection from the mounting surface for comfortable grip clearance
• Matte silver finish for a low-sheen, contemporary look
• Part of the Stanton collection for coordinated hardware selection

Compatibility

Designed as a direct-mount bar pull for standard cabinet doors and drawers with 448mm center-to-center hole spacing. Compatible with face-frame and frameless cabinet constructions that accept this hole spacing.

Installation Notes

Installation is typically performed by a cabinetmaker, finish carpenter, or experienced DIYer using a drill, template, and screwdriver. Pre-drill mounting holes to the correct center-to-center spacing before fastening. Verify cabinet door or drawer thickness is sufficient to accept the mounting screws without breakthrough. Do not overtighten fasteners, as this can crack or deform the cabinet face.