Boneham P2612GK Press Fit Headless Drill Bushing

Product Description

The BONEHAM P2612GK is a press fit headless drill bushing designed to guide drill bits with precision in jig and fixture applications. With a 0.209 inch inside diameter, a 13/32 inch outside diameter, and a 3/4 inch overall length, this bushing provides accurate drill guidance while maintaining a low-profile headless design that sits flush with the jig plate surface. Constructed from steel hardened to 60 to 65 HRC, it delivers the wear resistance required for repetitive drilling operations in production and maintenance environments.

This bushing is suited for use in drill jigs, fixture plates, and tooling setups where consistent hole location is critical. The press fit installation method locks the bushing securely into a prepared plate bore without fasteners. It carries an ANSI-standard industry code of P, making it a recognized fit within standard drill bushing systems. Machinists, toolmakers, and fixture builders in metalworking, manufacturing, and fabrication shops are the primary installers of this component.

Key Features

• Press fit installation method for secure, fastener-free retention in jig plates
• Headless design sits flush with the plate surface for clearance-sensitive applications
• Steel construction hardened to 60 to 65 HRC for extended wear life
• Inside diameter tolerance of +0.0001 to +0.0004 inches for precise drill guidance
• ANSI-standard P industry code for compatibility within standard bushing systems
• Non-renewable fixed bushing — intended for permanent installation

Compatibility

Designed as an ANSI-standard P-series press fit headless drill bushing for use in standard drill jig plates and fixture tooling requiring a 13/32 inch bore and a 0.209 inch drill guide diameter.

Installation Notes

Installation is performed by toolmakers or machinists using an arbor press to seat the bushing flush into a precision-bored jig plate hole. The receiving bore must be machined to the correct interference fit tolerance to ensure proper retention. Once pressed in, this bushing is not designed for removal and replacement. Always verify that the plate bore diameter and depth match the bushing outside diameter and overall length before pressing.