Southland 511-932HP Galvanized Hex Bushing 1/2x3/8 Pipe

Product Description

The SOUTHLAND 511-932HP is a galvanized hex bushing designed to connect two threaded pipes of different sizes in a single fitting. The male end measures 1/2 inch and the female end measures 3/8 inch, making it a standard reducing bushing for threaded pipe assemblies. Hot-dip or mill galvanization provides a zinc-based rust-resistant coating over the steel body, extending service life in moist or corrosive environments. Licensed plumbers, pipefitters, and experienced DIYers install this fitting where a pipe size reduction is required at a threaded joint.

This hex bushing is suited for residential and light commercial plumbing, compressed air distribution lines, and potable water supply systems. The hex profile allows a wrench to seat firmly during installation, reducing the risk of over-tightening or fitting damage. It is also used in drainage configurations and general-purpose pipe assemblies where a 1/2-inch-to-3/8-inch threaded reduction is needed. The galvanized finish makes it a practical choice for installations exposed to humidity or intermittent moisture.

Key Features

• Galvanized steel construction provides zinc-based corrosion resistance for extended service life
• 1/2 inch male NPT to 3/8 inch female NPT reducing configuration
• Hex body profile allows standard wrench engagement for controlled installation torque
• Suitable for potable water, compressed air, and drainage applications
• Sold individually with a minimum order quantity of one

Compatibility

Designed as a standard NPT threaded reducing hex bushing for use in residential and light commercial pipe systems requiring a 1/2-inch to 3/8-inch threaded reduction.

Installation Notes

Installation is typically performed by a licensed plumber or pipefitter in accordance with local plumbing codes and IPC guidelines. Shut off the water supply or depressurize the air line completely before removing or installing any threaded fitting. Apply an approved thread sealant tape or compound to the male threads before assembly. Do not use pipe wrenches or power tools to over-drive the fitting into the female connection, as cross-threading or fitting damage may result.