Msa 10148707 Hard Hat Replacement Suspension 4-point

Product Description

The MSA 10148707 is a replacement suspension designed for hard hats using the FAS-TRAC III suspension system. It provides the internal headband and support structure that keeps a hard hat properly positioned on the wearer during use. The suspension uses a 4-point attachment design and a ratchet adjustment mechanism, allowing quick sizing without removing the hat. At 0.72 pounds, it is a lightweight service component that safety managers, site supervisors, and equipment managers keep on hand for routine hard hat maintenance. Installation requires no special tools and is handled in the field.

This suspension is intended for use in industrial, construction, utilities, and general site environments where MSA hard hats equipped with the FAS-TRAC III system are in service. It is a direct service-replacement component used to restore the fit and protection function of a hard hat when the original suspension shows wear, damage, or loss of adjustment function. Sold individually, it suits single-unit replacement needs as well as small-quantity maintenance restocking.

Key Features

• 4-point suspension attachment for stable, balanced hard hat positioning
• Ratchet adjustment mechanism for tool-free, quick sizing in the field
• FAS-TRAC III system compatibility for direct drop-in replacement
• Lightweight construction at 0.72 pounds minimizes added load
• Sold as a single unit to support one-for-one replacement or small restocking

Compatibility

Designed as a replacement suspension for MSA hard hats equipped with the FAS-TRAC III suspension system. Verify that the existing hard hat shell accepts FAS-TRAC III suspension hardware before installation.

Installation Notes

Suspension replacement is performed by safety-qualified personnel or equipment managers following the hard hat manufacturer service instructions. Remove the worn suspension by releasing the attachment points from the shell before fitting the replacement. Inspect the hard hat shell for cracks or damage during the swap and retire any shell that fails visual inspection. Follow applicable ANSI Z89.1 and site safety program requirements when returning headwear to service.