KREG KMA2700 Circular Saw Track 48 in

Product Description

The KREG KMA2700 is a 48-inch aluminum circular saw track designed to guide most circular saws through straight, accurate rip, crosscut, and angled cuts in plywood, MDF, and sheet panels. The track features anti-slip guide strips on the underside that hold it firmly against the workpiece without clamps, and anti-chip strips along the cut edge that support material fibers to prevent splintering. A starting block built into the track positions the saw at the correct entry point while allowing the blade guard to operate normally. This track is sold as a package of two and weighs 10.1 pounds total. It is installed and used by finish carpenters, cabinet makers, and woodworking tradespeople who require repeatable, clean cuts on sheet goods.

The KMA2700 is suited for job-site and shop applications where long straight cuts in full or partial sheet goods are required. It handles rip cuts, crosscuts, and angled cuts up to 48 inches in length, making it practical for cutting plywood, MDF, and similar panel materials. The universal design is compatible with most standard circular saws, eliminating the need for a dedicated track-saw system. It is commonly used in millwork, cabinet installation, flooring prep, and general finish carpentry work.

Key Features

• 48-inch aluminum track guides circular saws through rip, crosscut, and angled cuts up to 48 inches
• Anti-slip guide strips hold the track in position on the workpiece without requiring clamps
• Anti-chip strips support material at the cut line to reduce splintering on plywood and MDF
• Starting block positions the saw correctly at entry and allows normal blade guard operation
• Universal design compatible with most circular saws, no proprietary saw required
• Aluminum construction for durability and consistent straightness along the guide edge

Compatibility

Designed for use with most standard circular saws. No specific brand or model compatibility was stated by the manufacturer in available product data.

Installation Notes

Position the track on the workpiece aligned with the cut mark before powering on the saw. Verify the anti-slip strips are fully in contact with the material surface before beginning the cut. Disconnect power to the saw and confirm the blade guard moves freely before each use. Follow all applicable workshop safety practices and tool-manufacturer guidelines when operating circular saws with guide track accessories.