Gilmour 807764-1001 Hose Connector 3/4 in Nh Female Brass

Product Description

The GILMOUR 807764-1001 is a female-to-female garden hose connector machined from brass. It joins two female-threaded garden hose ends using standard 3/4-inch NH (National Hose) threads on both sides. This type of fitting is used to couple two hose sections that would otherwise be incompatible without a double-male adapter or to reconnect a hose whose male end has been damaged. The brass construction resists corrosion and handles the pressure cycles common in residential and light commercial irrigation and wash-down applications. Plumbers, irrigation techs, and experienced DIYers install this fitting as a direct repair or extension solution.

This connector suits residential garden and lawn irrigation setups where two female hose ends need to be joined inline. It is compatible with standard 3/4-inch NH threaded garden hoses and fittings found on most North American residential hose bibbs, hose reels, and spray equipment. The compact brass body fits in tight routing situations near spigots, timers, or manifold assemblies.

Key Features

• Female-to-female configuration joins two standard garden hose female ends directly
• 3/4-inch NH threads on both sides match North American residential hose standards
• Brass material provides corrosion resistance for outdoor and irrigation use
• Compact body at 1.5 inches length keeps installation profile low
• Single-piece construction with no internal components to fail or replace

Compatibility

Designed as a standard replacement fitting for residential and light commercial garden hose systems using 3/4-inch NH threaded connections.

Installation Notes

Turn off the water supply at the hose bibb or shutoff valve before connecting or disconnecting hose fittings. Thread both female hose ends onto the connector by hand first, then snug with pliers if needed — avoid over-tightening brass fittings, as the threads can strip or crack the fitting body. Wrapping the connector threads with PTFE tape is not standard practice on NH hose threads but may help seal worn or damaged threads. This fitting is intended for low-pressure residential hose applications and should not be used in high-pressure hydraulic or potable water supply line service.