Dakota Sourcing 13003 90 Degree Copper Elbow 1/2 in

Product Description

The DAKOTA SOURCING 13003 is a 90-degree copper elbow fitting designed for sweat (copper-to-copper) connections in residential and commercial plumbing and HVAC refrigerant piping systems. With an outside diameter of 0.5 inches and an inside diameter of 0.375 inches, this fitting directs copper tubing at a right angle without the need for additional adapters. It is installed by licensed plumbers and HVAC technicians as a standard component in supply lines, drain systems, and refrigerant circuits where a directional change is required.

This copper elbow is suited for use in residential plumbing rough-in work, commercial pipe runs, and HVAC refrigerant line sets where a 90-degree change of direction is needed. The C x C (copper by copper) configuration accepts standard copper tubing on both ends and is compatible with sweat-solder joining methods. It is commonly installed in tight spaces where tube bending is not practical or code-compliant.

Key Features

• 90-degree angle for right-angle directional changes in copper pipe runs
• C x C (sweat x sweat) end connections for solder joining on both ends
• 0.5 inch outside diameter and 0.375 inch inside diameter for standard copper tubing sizing
• Copper construction provides corrosion resistance and long service life in wet environments
• Compatible with standard sweat-solder joining techniques used in plumbing and HVAC applications

Compatibility

Designed as an OEM-style replacement or new-installation copper sweat elbow for use with standard copper tubing in residential and commercial plumbing and HVAC refrigerant piping systems.

Installation Notes

Installation of this fitting is typically performed by a licensed plumber or HVAC technician following applicable local plumbing codes and IFGC or IPC standards. Shut off the water supply or isolate the refrigerant circuit completely before cutting into any existing line. Clean and flux both the fitting socket and tube end before applying heat with a torch for soldering. Do not overheat the fitting, as excessive heat can damage the copper or cause incomplete solder joints.