B K/mueller Inds(import) 563-060HN Galvanized Nipple

Product Description

The B K/MUELLER INDS(IMPORT) 563-060HN is a galvanized steel pipe nipple measuring 1/2 inch in diameter and 6 inches in length. Pipe nipples are short sections of externally threaded pipe used to connect two female-threaded fittings, valves, or equipment ports in a piping system. The galvanized zinc coating provides corrosion resistance, making this nipple suitable for water supply, irrigation, gas distribution, and general plumbing applications. Licensed plumbers, pipefitters, and mechanical contractors install this type of fitting as a standard component in both new construction and retrofit piping assemblies.

This nipple is suited for residential and light commercial plumbing and mechanical systems where a 1/2-inch threaded connection point is required. Typical applications include water supply risers, boiler piping, compressed air lines, and gas distribution branch lines. The 6-inch length provides enough extension to clear flanges, walls, or equipment housings where close nipples or short nipples would not reach. This SKU is packaged in quantities of 20 units per package, making it practical for contractors maintaining job-site inventory.

Key Features

• 1/2-inch nominal pipe size with 6-inch overall length for versatile reach in tight assemblies
• Galvanized zinc coating provides corrosion resistance in wet and humid environments
• Steel construction delivers strength suitable for standard plumbing and mechanical pressure ratings
• Externally threaded on both ends for direct connection to female NPT fittings and valves
• Packaged 20 units per package for contractor and jobsite stocking convenience

Compatibility

Designed as a standard 1/2-inch NPT galvanized pipe nipple for use in residential and commercial plumbing, mechanical, and gas piping systems requiring threaded steel pipe connections.

Installation Notes

Installation is typically performed by a licensed plumber or pipefitter. Shut off and depressurize the affected line before removing or installing any threaded fitting. Apply approved pipe thread sealant or PTFE tape to male threads before assembly, and hand-tighten before finishing with a pipe wrench. For gas applications, verify compliance with local codes and the International Fuel Gas Code (IFGC) before placing the system back in service.