B K Mueller 510-603HN Galvanized Equal Tee 0.5 in

Product Description

The B K Mueller Industries 510-603HN is a 1/2-inch galvanized equal tee fitting used in threaded pipe systems for water distribution, gas lines, and general plumbing. This tee connects three sections of 1/2-inch pipe at a 90-degree branch, maintaining equal flow diameter across all three ports. The galvanized steel construction provides corrosion resistance suited for both above-ground and exposed indoor installations. Licensed plumbers and pipefitters install this type of fitting in residential and light commercial systems where threaded iron pipe assemblies are specified.

This fitting is appropriate for residential and commercial plumbing rough-in work, water supply lines, and low-pressure gas distribution systems where galvanized threaded pipe is the specified material. It is sold in packages of 15 units, making it a practical choice for contractors working on multi-fixture or multi-run installations. The equal tee configuration means all three openings share the same 1/2-inch nominal pipe size, simplifying layout and reducing the number of SKUs needed on a job.

Key Features

• Equal tee design with matching 1/2-inch openings on all three ports
• Galvanized steel construction for corrosion resistance in exposed or damp environments
• Threaded connections compatible with standard NPT pipe threads
• Packaged in quantities of 15 units per package for contractor convenience
• Suitable for water distribution and low-pressure piping applications

Compatibility

Designed as an OEM-style replacement and standard-use fitting for 1/2-inch nominal threaded galvanized pipe systems in residential and commercial plumbing applications.

Installation Notes

Installation is performed by a licensed plumber following applicable IPC or local plumbing code requirements. Shut off and depressurize the supply line before disassembling any threaded pipe joint. Apply pipe thread sealant tape or compound to male threads before assembly and tighten to hand-tight plus the appropriate number of turns using a pipe wrench. Do not over-tighten, as this can crack fittings or damage threads.