

Ships same day if ordered by 12 pm
Manufacturer pricing rules prevent us from advertising our discount — no account or email required to see it.
Secure Payments
Easy Returns
Expert Advice
Fast Shipping
The WILLIAMS COMFORT PRODUCTS P-5 is a pin punch designed for driving out pins, roll pins, and fasteners in mechanical assemblies. With a 5/32-inch point diameter and an overall length of 5 inches, it provides the reach and precision needed for close-tolerance work on HVAC equipment, plumbing fixtures, and general mechanical components. The compact form factor and defined tip geometry allow controlled strikes with minimal slippage in confined spaces. This is a hand tool used by licensed trade professionals during installation, maintenance, and repair procedures.
The P-5 pin punch is suited for residential and light commercial service work where removing or seating roll pins, drift pins, or tapered pins is part of the job. Typical applications include disassembling valve assemblies, bearing housings, linkage components, and mechanical couplings encountered in HVAC, plumbing, and related trade work. Its 5-inch length makes it practical for moderately recessed fastener locations without requiring an extended punch.
Designed as a general-purpose pin punch suitable for use on mechanical assemblies encountered in HVAC, plumbing, electrical, and related trade service applications.
Pin punches are used by licensed trade professionals and experienced service technicians. Always power down or de-energize equipment and relieve system pressure before disassembling mechanical components. Use a ball-peen or mechanics hammer sized appropriately for the work, and wear eye protection during all punch operations. Never use a pin punch as a pry tool or substitute for a drift punch on tapered fasteners.
Thanks for subscribing!
This email has been registered!