Wiha 27393 7 Pc Phillips Slotted Screwdriver Set

Product Description

The WIHA 27393 is a 7-piece screwdriver set combining Phillips and slotted drivers in a compact vinyl pouch. Shanks are round and machined from chrome-vanadium-molybdenum tool steel, delivering the torsional strength and edge retention that trade work demands. Each tip is precision machined for an exact fit, reducing cam-out and fastener damage. A hard chrome finish protects against corrosion in wet or chemically active environments. Handles are molded directly onto the shank and proportioned to blade size for controlled torque. The rotating cap at the top of each handle allows steady one-finger pressure during precision work. The set weighs approximately 0.5 pounds and ships in a vinyl pouch for organized storage on the job.

This set is suited for residential and light commercial electrical, HVAC control wiring, panel work, and general mechanical service where a range of small fastener sizes is needed. The two Phillips drivers cover sizes 0 and 1, handling fine terminal screws and equipment covers. The five slotted drivers span 2.00 mm through 4.00 mm, addressing the range of slot widths found in control boards, junction boxes, and switchgear. Electricians, HVAC technicians, and plumbers will find this set useful for low-voltage wiring, thermostat installation, and equipment commissioning.

Key Features

• Chrome-vanadium-molybdenum tool steel shanks for high torsional strength and long tip life
• Precision machined tips for exact fastener fit and reduced cam-out
• Hard chrome corrosion-protective finish on all shanks
• Rotating cap enables controlled single-finger turning for precision fastening
• Handles molded directly to blade and proportioned to shank size for balanced grip
• Vinyl pouch keeps all 7 drivers organized and protected during transport

Compatibility

Designed as a general-purpose hand tool set for use across residential and commercial trade applications requiring Phillips 0 and 1 and slotted drivers from 2.00 mm to 4.00 mm.

Installation Notes

Always de-energize electrical circuits and follow lockout/tagout procedures before using screwdrivers on live equipment enclosures. Note that these drivers are not rated as insulated tools under IEC 60900 and should not be used on energized conductors. Select the correct driver size before applying torque to avoid fastener damage. Keep tips clean and inspect for wear before each use.