Whirlpool WPW10405846 Dryer Control Board

Product Description

The WHIRLPOOL WPW10405846 is a Central Control Unit (CCU) board designed for residential electric and gas dryers. It serves as the main logic controller, managing cycle selection, motor operation, heating sequences, and sensor inputs throughout the drying process. Measuring 11.75 x 5.25 x 5.75 inches and weighing 1 pound, this board is a direct OEM-style replacement for technicians servicing Whirlpool and Maytag platform dryers. Appliance repair technicians and HVAC-trained service pros familiar with residential laundry equipment handle this installation.

This control board fits a wide range of residential electric and gas dryer models built on the shared Whirlpool-Maytag platform, including both 240-volt electric units and natural gas or LP gas configurations. It is suited for service calls involving failed cycle starts, unresponsive controls, error codes, or no-heat conditions traced back to the main board. Compatible model numbers are listed in the Compatibility section below.

Key Features

• Direct OEM replacement CCU board for Whirlpool and Maytag residential dryers
• Controls cycle logic, motor sequencing, and heating element or burner activation
• Compact form factor at 11.75 x 5.25 x 5.75 inches for drop-in fitment
• Lightweight at 1 pound for straightforward handling during service
• Addresses common failure symptoms including dead controls, mid-cycle shutoffs, and fault codes

Compatibility

Compatible with the following models: 7MWGD9270XR1, 7MWGD9270XL0, 7MWGD9270XR0, 7MWGD9270XL1, MGDE301YG0, MEDE301YW0, MGDE301YW0, MEDE301YG0, WED9270XL1, WGD9371YL0, WGD9270XW1, WGD9270XL1, WED9270XW1, WGD9270XR0, WED9270XR1, WED9371YL0, WED9270XL0, WED9270XL2, WED9371YW0, WGD9270XW0, WGD9270XL0, WGD9371YW0, WED9270XW0, WED9270XR2, WGD9270XR1.

Installation Notes

Disconnect power to the dryer at the breaker or by unplugging the unit before beginning any control board service. For gas dryer models, also shut off the gas supply valve as a standard precaution. A nut driver set and Phillips screwdriver are typical tools required to access the control housing. Transfer all wiring harness connectors carefully and confirm each connector is fully seated before restoring power and testing operation.