Whirlpool W11647667 Dishwasher Console Assembly

Product Description

The WHIRLPOOL W11647667 is a replacement console assembly designed for select Whirlpool dishwasher models. This assembly houses the user interface controls that allow the operator to select wash cycles, options, and initiate operation. It mounts along the top interior edge of the door panel and is a direct OEM-specification replacement component. The unit measures 6.75 inches by 31.0 inches by 4.25 inches and weighs 1 pound. Installation is typically performed by an appliance technician during control interface failure, water damage to the control surface, or cosmetic replacement of the stainless steel panel finish.

This console assembly is intended for residential built-in dishwashers in the Whirlpool WDF340 and WDF341 series. It is applicable in standard 24-inch dishwasher installations where the original console has experienced control failure, physical damage, or wear. Compatible model numbers are listed below in the Compatibility section. This part is relevant to service calls involving unresponsive cycle selectors, damaged fascia, or complete control panel replacements on the listed units.

Key Features

• OEM-specification console assembly for WDF340 and WDF341 series dishwashers
• Stainless steel finish matches original door panel aesthetics
• Dimensions of 6.75 inches by 31.0 inches by 4.25 inches for direct fit installation
• Lightweight at 1 pound for straightforward door panel handling during service
• Replaces the full user-interface console in a single assembly swap

Compatibility

Compatible with the following Whirlpool dishwasher models: WDF341PAPT2, WDF341PAPB0, WDF341PAPT0, WDF341PAPB2, WDF341PAPM1, WDF341PAPW1, WDF340PAMB0, WDF340MAMW0, WDF341PAPB1, WDF341PAPT1, WDF341PAPW2, WDF341PAPM0, WDF341PAPW0, WDF340PAMT0, WDF341PAPM2, WDF340MAMM0.

Installation Notes

Console assembly replacement on a residential dishwasher should be performed by a qualified appliance technician. Disconnect power to the unit at the circuit breaker before beginning any disassembly of the door panel. The inner door liner and any retaining screws must be removed to access and release the existing console assembly. Take care not to pinch or stress wire harness connectors during removal and reinstallation.