Whirlpool W11356990 Communication Harness Oven

Product Description

The WHIRLPOOL W11356990 is a OEM communication harness designed for Whirlpool wall oven and microwave combination units. This wiring harness carries communication signals between the oven and microwave control systems, allowing the two appliance sections to coordinate operation. It measures 12.0 inches in length with a cross-section of 1.5 by 1.0 inches in its packaged form. Installation is performed by qualified appliance technicians during diagnostic replacement or unit servicing. This is a direct OEM replacement part sourced from Whirlpool, ensuring correct connector fit and signal compatibility with the target control boards.

This communication harness is used in Whirlpool built-in wall oven and microwave combination appliances. It connects internal control assemblies and is typically replaced when communication faults or error codes indicate a wiring failure between the oven and microwave sections. The part is suited for residential appliance installations and is a common replacement during warranty or out-of-warranty service calls on affected model families.

Key Features

• OEM Whirlpool replacement communication harness for wall oven and microwave combo units
• Carries inter-module communication signals between oven and microwave control boards
• Direct fit replacement with factory-matched connectors
• Compact form factor at 12.0 inches in length
• Compatible with a broad range of WOC-series Whirlpool combination appliance models

Compatibility

Compatible with the following Whirlpool models: WOC75EC0HS04, WOC54EC0HW03, WOC54EC7HS02, WOC54EC7HW04, WOC54EC7HW02, WOC54EC7HS04, WOC97EC0HZ03, WOC75EC7HS02, WOC54EC0HB03, WOC54EC7HB02, WOC75EC7HS04, WOC75EC0HV03, WOC54EC0HS03, WOC54EC7HB04, WOC75EC7HV03, WOC54EC7HS03, WOC54EC0HW04, WOCA7EC0HN02, WOC54EC7HW03, WOC75EC0HS03, WOC97EC0HZ02, WOC54EC0HB04, WOC75EC7HS03, WOC54EC0HS04, WOC54EC7HB03.

Installation Notes

This harness should be installed by a qualified appliance technician. Disconnect power to the appliance at the circuit breaker before beginning any disassembly or wiring work. Handle connectors carefully to avoid damaging locking tabs during removal and reinstallation. Verify the replacement harness routing matches the original to prevent pinching or contact with heat sources inside the appliance cavity.