Whirlpool W10480123 Washer Control Board 120V

Product Description

The WHIRLPOOL W10480123 is a central control unit (CCU) assembly designed for high-efficiency top-load washing machines operating at 120 volts. This board serves as the primary electronic brain of the washer, managing cycle logic, motor control, water valve sequencing, and user interface communication. It is an OEM-specification replacement component, intended for installation by appliance service technicians working on residential top-load units. Measuring 15.25 inches by 5.25 inches by 5.75 inches and weighing approximately 1 pound, the board is a direct drop-in replacement that restores full machine functionality when the original CCU fails.

This control board is used in residential top-load high-efficiency washing machines. It is typically replaced when the washer exhibits symptoms such as failure to advance through cycles, unresponsive controls, error codes related to control communication, or complete loss of machine operation. The board applies specifically to WTW5610 series machines and is confirmed compatible with model numbers WTW5610XW3 and WTW5610XW2. Installation is performed during a service call where the original CCU has been diagnosed as faulty through standard diagnostic procedures.

Key Features

• OEM-specification central control unit for WTW5610 series top-load washers
• Operates at 120 volts to match factory electrical requirements
• Manages cycle sequencing, motor control, and valve timing
• Compact form factor at 15.25 x 5.25 x 5.75 inches for direct-fit installation
• Lightweight at 1 pound for straightforward handling during service

Compatibility

Compatible with the following Whirlpool top-load washer models: WTW5610XW3 and WTW5610XW2.

Installation Notes

Installation should be performed by a qualified appliance service technician. Before servicing, disconnect the washer from its 120-volt power supply and allow any residual capacitor charge to dissipate. The control board is typically accessed by removing the washer cabinet or console panel depending on design; consult the service manual for the specific model being serviced. Do not handle the board by its electrical connectors, and ensure all harness plugs are fully seated before restoring power.