Whirlpool 2311639 Ice Dispenser Wire Harness

Product Description

The WHIRLPOOL 2311639 is an OEM replacement wire harness assembly for the ice dispenser light circuit on Whirlpool side-by-side refrigerators. This assembly routes low-voltage power to the dispenser light, maintaining proper illumination and electrical continuity within the dispenser housing. At 17.0 inches in length, the harness is sized for a direct, factory-fit installation with no splicing or modification required. Licensed appliance technicians and experienced service pros install this part when diagnosing a failed or non-illuminating ice dispenser light on compatible units. Its 1.0 pound weight reflects a compact, single-circuit wire bundle.

This wire assembly is designed for residential side-by-side refrigerators equipped with an ice and water dispenser. It supports the light circuit within the dispenser door panel, making it the correct replacement when the dispenser lamp circuit has failed, sustained wire damage, or shows signs of connector corrosion. It is applicable across a broad range of Whirlpool and related brand models in the ED2, ED5, BRS, and CS series refrigerator families listed below.

Key Features

• OEM replacement harness ensures factory-spec fit and electrical compatibility
• Dedicated light circuit wiring for ice dispenser illumination
• 17.0-inch length supports direct routing within the dispenser door panel
• Pre-terminated connectors eliminate field splicing
• Lightweight single-circuit bundle at 1.0 pound

Compatibility

Compatible with the following Whirlpool refrigerator models: ED5HHGXTQ00, ED5FHEXVB00, ED5FHEXVL00, CS22CFXTS00, ED5FHEXVQ00, BRS62ABANA00, ED2FHEXVB00, ED2FHEXVL00, ED2FHEXVQ00, ED5HBEXTB00, ED5HBEXTB01, ED5HBEXTL01, ED5HBEXTQ00, ED5HBEXTQ01, ED2HBEXTB00, ED2HBEXTB01, ED2HBEXTL01, ED2HBEXTQ00, ED2HBEXTQ01, ED5HHEXTB00, ED5HHEXTL00, ED5HHEXTQ00, ED5CHQXTT00, ED2HHEXTB00, ED2HHEXTL00.

Installation Notes

Installation should be performed by a qualified appliance technician. Disconnect power to the refrigerator at the wall outlet or circuit breaker before accessing the dispenser panel or any wiring. Carefully release the existing connector locks before pulling connectors to avoid damaging the housing or adjacent wiring. Verify the replacement harness routing matches the original path before securing the door panel.