West Penn Wire 25210IV1000 2C 10 Awg Plenum Cable 1000 Ft

Product Description

The WEST PENN WIRE 25210IV1000 is a 2-conductor, 10 AWG stranded unshielded cable with a plenum-rated jacket, designed for low-voltage signal and power distribution applications in commercial and institutional buildings. The plenum jacket meets fire and smoke requirements for installation in air-handling spaces without conduit. With 10 AWG stranded conductors, the cable handles moderate current loads while maintaining flexibility during pull-through installation. Electricians and low-voltage technicians install this cable in plenum ceilings, raised floors, and air-return pathways where local fire codes require a plenum-rated assembly.

This cable is suited for commercial building wiring projects including audio distribution, intercom systems, access control, and general-purpose low-voltage circuits. Its unshielded construction keeps it lightweight and easy to route in bulk conduit or open plenum spaces. The 1000-foot put-up length supports full floor or zone runs without mid-run splices, reducing labor time on larger projects.

Key Features

• Plenum-rated jacket approved for air-handling space installation without conduit
• 2-conductor configuration for two-wire circuit runs
• 10 AWG stranded conductors for flexibility and moderate current capacity
• Unshielded construction keeps cable diameter small and routing simple
• 1000-foot reel length reduces splices on long commercial runs

Compatibility

Designed as a general-purpose 2-conductor plenum-rated cable suitable for low-voltage audio, intercom, access control, and signal wiring applications in commercial environments.

Installation Notes

Installation in plenum air-handling spaces must comply with NFPA 90A and applicable local fire codes requiring plenum-rated cable. De-energize all circuits before terminating conductors. Low-voltage electricians or licensed electrical contractors should perform installation per NEC Article 725 or the applicable low-voltage wiring code for the specific application. Avoid sharp bends that exceed the cable minimum bend radius to prevent conductor or jacket damage during pull-through.