Wera 05028045001 Preset Torque Screwdriver T15 Torxplus

Product Description

The WERA 05028045001 is a preset torque screwdriver designed for controlled fastening applications where consistent torque delivery is critical. Set to a fixed maximum torque of 3 Nm, this tool eliminates the risk of over-torquing fasteners during assembly or service work. The driver features a T15 TorxPlus drive in the IP15 fractional size, with an overall length of 7.5 inches and a shaft length of 2.56 inches. Torque accuracy is rated at plus or minus 10 percent, meeting the repeatability demands of precision mechanical and electrical work. At 0.2 pounds, it is lightweight enough for frequent single-handed use in tight service environments.

This preset torque screwdriver is suited for residential and light commercial service applications requiring repeatable low-torque fastening. Typical use cases include control board mounting, panel assembly, and any fastening task where a specific maximum torque limit must not be exceeded. The TorxPlus IP15 drive is commonly encountered in HVAC controls, electrical enclosures, and precision equipment. Because the torque value is factory preset, this tool is particularly useful in field service kits where technicians need a no-adjustment solution.

Key Features

• Factory preset at 3 Nm maximum torque for consistent, repeatable results
• Plus or minus 10 percent torque accuracy for reliable fastening control
• T15 TorxPlus IP15 drive for compatibility with precision torx fasteners
• 7.5 inch overall length with a 2.56 inch shaft for access in confined spaces
• Lightweight at 0.2 pounds, suited for extended single-handed use
• Non-tethered design; single-piece tool requiring no additional components

Compatibility

Designed for use with T15 TorxPlus IP15 fasteners in applications requiring a preset torque limit of 3 Nm.

Installation Notes

This tool is intended for use by technicians performing controlled-torque fastening on precision components. Before servicing any electrical or mechanical assembly, de-energize the equipment and follow all applicable lockout/tagout procedures per NFPA 70E or site safety standards. Apply fastener torque smoothly and allow the preset clutch to disengage naturally at the set limit rather than forcing past the stop. Do not attempt to adjust the preset torque mechanism, as the driver is factory-calibrated and not user-adjustable.