Wera 05017015001 Phillips Screwdriver No. 3 6 Inch

Product Description

The WERA 05017015001 is a No. 3 Phillips screwdriver built for professional use in HVAC, electrical, plumbing, and general mechanical service work. The blade measures 6 inches in length with a hexagonal anti-roll shank, and the ergonomic handle runs 4.375 inches long with a 1.5625-inch diameter. A black-point hardened tip and impact cap with bolster allow this tool to handle both standard fastening and chiseling tasks. Hard gripping zones support high-torque, high-speed driving with reduced hand fatigue. Licensed trades and service techs who spend hours on fasteners will appreciate the low-fatigue design built into the handle geometry.

This screwdriver is suited for residential and commercial service applications where a No. 3 Phillips drive is required. Typical uses include securing electrical panel components, HVAC equipment access panels, blower assembly hardware, and plumbing fixture mounting. The hexagonal shank allows a wrench or open-end spanner to be applied at the shank for increased torque when breaking loose stubborn fasteners. The chiseldriver construction also makes it usable for light chiseling and loosening tasks beyond standard screw driving.

Key Features

• No. 3 Phillips tip with black-point hardened treatment for extended tip life
• 6-inch blade with hexagonal anti-roll shank prevents workbench roll and allows wrench assist
• Impact cap and bolster support struck and chiseling use in addition to standard driving
• Ergonomic handle with hard gripping zones for high-speed, low-fatigue operation
• Optimized corrosion protection on blade for service environments exposed to moisture
• Not tether capable - verify site requirements before use at elevation

Compatibility

Designed for use with No. 3 Phillips fasteners commonly found in HVAC equipment, electrical enclosures, plumbing fixtures, and general mechanical assemblies requiring a standard No. 3 tip profile.

Installation Notes

This tool is used by licensed electricians, HVAC technicians, and plumbers as part of standard hand-tool service kits. Always de-energize electrical equipment and follow lockout-tagout procedures before using any hand tool on live panels or control boards. The hexagonal shank is designed to accept a wrench for additional torque - use controlled force to avoid fastener damage. Inspect the tip before each use and replace if the point shows wear, rounding, or chipping that could cam out of the fastener head.