Wera 05007610001 Slotted Screwdriver 3/16 in Blade

Product Description

The WERA 05007610001 is a standard slotted screwdriver built for trade professionals who need a reliable, everyday driver for terminal screws, cover plates, and general fastening work. The blade measures 3/16 inches wide and 4 inches long, giving enough reach for most panel and junction box applications without the bulk of a longer driver. The round shank runs inside an ergonomic handle that measures 3-3/4 inches in length and 1-19/64 inches in diameter, providing a secure grip during both driving and extraction. Total overall length is 7-3/4 inches. Licensed electricians, HVAC technicians, and plumbers will find this a practical addition to any service kit.

This screwdriver suits residential and light commercial service work where slotted fasteners remain common - terminal blocks, equipment access panels, electrical enclosures, and control board covers. The 3/16-inch tip width fits standard slotted screw heads found throughout HVAC equipment, plumbing fixtures, and electrical panels. The compact 7-3/4-inch overall length works well in confined spaces such as air handler cabinets and electrical boxes where clearance is limited.

Key Features

• 3/16-inch blade width fits standard slotted fasteners across HVAC, electrical, and plumbing applications
• 4-inch blade length provides reach without excessive length in tight spaces
• Round shank design allows use with a wrench for added torque when needed
• Ergonomic handle at 3-3/4 inches long and 1-19/64 inches in diameter for a comfortable, controlled grip
• 7-3/4-inch overall length balances reach and maneuverability in confined work areas

Compatibility

Designed as a standard slotted screwdriver suitable for general trade use wherever a 3/16-inch slotted tip is required.

Installation Notes

Use this screwdriver for manual fastener driving only - do not use it as a pry bar or chisel. De-energize all electrical circuits before working inside panels or terminal enclosures, following applicable NEC guidelines. Inspect the tip for wear or rounding before use, as a damaged tip can slip and damage fastener heads or nearby components.