Wera 05006152001 Insulated Phillips Screwdriver No. 1

Product Description

The WERA 05006152001 is an insulated Phillips screwdriver rated to IEC 60900 and VDE standards, designed for electricians and other trade professionals working on or near energized equipment. The tool features a No. 1 Phillips tip with WERA Lasertip surface treatment, which bites into fastener heads to reduce cam-out. The blade is 3.125 inches long with a round shank, and the ergonomic plastic handle measures 3.875 inches in length with a 33 mm diameter. At 0.8 pounds, it is a lightweight daily-use tool built for sustained work in panel, fixture, and device-level electrical service.

This screwdriver is suited for residential and commercial electrical work where insulated hand tools are required by code or job-site safety policy. Typical applications include driving No. 1 Phillips fasteners on electrical devices, cover plates, fixture boxes, and control panels. The hexagonal anti-roll geometry on the handle prevents the tool from rolling off surfaces when set down. The Take it Easy Tool Finder color system and red handle make it easy to locate in a tool bag or on a cluttered work surface. It is individually tested at the factory prior to shipment.

Key Features

• Insulated to IEC 60900 and VDE standards for work on or near live circuits
• Lasertip tip treatment bites into fastener heads and reduces cam-out
• Hexagonal anti-roll handle geometry prevents the tool from rolling off flat surfaces
• Ergonomic red plastic handle with 33 mm diameter for low-fatigue extended use
• Individually factory-tested before shipment
• Not tether capable - not rated for elevated drop-zone applications requiring tethered tools

Compatibility

Designed for use with No. 1 Phillips head fasteners in residential and commercial electrical, HVAC, and panel work where IEC 60900 or VDE-rated insulated hand tools are specified.

Installation Notes

This tool is intended for installation by licensed electricians or qualified trade professionals. Always verify the tool's insulation is undamaged before use near energized conductors. Even with a VDE-rated insulated screwdriver, follow all applicable NFPA 70E and site-specific electrical safety protocols before working on live equipment. Do not use if the handle or blade insulation shows cuts, cracks, or deterioration.