Wera 05006150001 Insulated Phillips Screwdriver No. 0

Product Description

The WERA 05006150001 is a No. 0 insulated Phillips screwdriver built for electricians and trade professionals working on live or potentially energized equipment. The blade measures 3.19 inches in length with a round shank, and the ergonomic red plastic handle measures 3.19 inches for a total compact form factor suited to tight work areas. The screwdriver meets IEC 60900 and VDE standards for insulated hand tools, meaning each unit is individually tested before leaving the factory. The Lasertip tip geometry is machined to grip Phillips screw heads firmly, reducing cam-out and operator fatigue during repetitive fastening tasks.

This screwdriver is suited for residential and commercial electrical service work, panel work, control wiring, and any application where contact with energized conductors is a risk. The ergonomic handle with a smooth hard zone and hexagonal anti-roll geometry keeps the tool from rolling off surfaces between uses. It is sized for No. 0 Phillips fasteners commonly found in electrical enclosures, terminal blocks, and light-duty control components. At 0.7 pounds it is easy to carry in a tool pouch or service bag for daily field use.

Key Features

• Insulated Phillips tip rated to IEC 60900 and VDE standards, individually tested
• Lasertip point geometry reduces cam-out on No. 0 Phillips fasteners
• Hexagonal anti-roll handle prevents the tool from rolling off work surfaces
• Ergonomic red plastic handle with smooth hard zone for low-fatigue extended use
• Round shank with 3.19-inch blade length suited to confined electrical enclosures
• Take it Easy Tool Finder color and size coding for fast tool identification

Compatibility

Designed for use with No. 0 Phillips head fasteners in electrical panels, control enclosures, and terminal assemblies where insulated tooling is required by code or job-site policy.

Installation Notes

This screwdriver is intended for use by qualified electricians working on or near energized equipment in compliance with applicable electrical codes including NFPA 70E arc flash and shock protection requirements. Always verify the insulation rating is intact and undamaged before use on energized circuits. Do not use as a pry bar or chisel, as damage to the insulation sleeve voids the VDE rating. Store separately from uninsulated tools to prevent surface damage to the insulation.