Walter Surface Technologies 13M464 Crimped Wheel Brush

Product Description

The WALTER SURFACE TECHNOLOGIES 13M464 is a crimped wire wheel brush designed for surface preparation and finishing on non-ferrous metal and stainless steel workpieces. It mounts via a threaded 5/8-11 arbor hole and runs at a maximum rated speed of 4,000 RPM, making it suited for die grinder applications where controlled material removal and surface conditioning are required. The crimped wire fill conforms to irregular surfaces and delivers consistent scratch patterns without the aggressive cut of knotted configurations. At 4.5 inches in outside diameter with a 2-inch face width, it covers a practical working area for weld cleanup, deburring, and surface blending tasks. Licensed tradespeople working in metal fabrication, maintenance, and industrial service will find this brush a straightforward fit for their angle grinder and die grinder setups.

This wheel brush is intended for use on non-ferrous metals and stainless steel surfaces. It is a standard die grinder attachment used in fabrication shops, pipefitting, and general industrial maintenance. The threaded arbor mount allows direct installation on compatible die grinder spindles without additional adapters. Typical applications include weld bead cleanup, rust and scale removal, and surface preparation prior to coating or inspection. Its 1-inch trim length and fine filament wire diameter in the 0.010 to 0.0199-inch range make it appropriate for finishing passes rather than heavy stock removal.

Key Features

• 4.5-inch outside diameter with a 2-inch face width for broad surface coverage
• Crimped stainless steel wire fill rated for non-ferrous metal and stainless steel applications
• Threaded 5/8-11 arbor hole for direct die grinder spindle mounting
• Maximum rated speed of 4,000 RPM
• Filament wire diameter in the 0.010 to 0.0199-inch range for controlled finishing action
• 1-inch trim length provides consistent wire contact pressure during use

Compatibility

Designed for use with die grinders equipped with a 5/8-11 threaded spindle. Compatible material applications include non-ferrous metal and stainless steel surfaces.

Installation Notes

Installation should be performed by qualified personnel familiar with abrasive wheel safety standards and applicable ANSI or OSHA guidelines for powered wire brush use. Disconnect and lock out the grinder from its power source before mounting or removing the brush. Thread the brush securely onto the 5/8-11 spindle and confirm it is seated fully before operating. Always verify that the tool RPM rating does not exceed the brush maximum rated speed of 4,000 RPM, and use appropriate eye and face protection during operation.