Walter Surface Technologies 11T262 Type 1 Cut-off Wheel

Product Description

The WALTER SURFACE TECHNOLOGIES 11T262 is a Type 1 straight cut-off wheel designed for fast, clean cutting on steel and stainless steel. Built with aluminum oxide abrasive and a resinoid bond, it measures 6 inches in diameter and 1/16 inches thick, with a 7/8 inch arbor hole. At a 36 grit rating and a maximum rated speed of 10,200 RPM, this wheel delivers aggressive material removal in demanding fabrication and field service environments. It is reinforced for added durability and carries an A36 specification designation. Licensed tradespeople and metalworkers in HVAC, plumbing, and general construction rely on this wheel for precise, controlled cuts.

This cut-off wheel is intended for use with standard angle grinders. It is suited for cutting steel and stainless steel in residential and commercial job-site applications, including pipe cutting, sheet metal work, structural steel fabrication, and equipment installation. Its Type 1 flat profile is compatible with the side guard configurations required for right-angle and small angle grinders.

Key Features

• Type 1 flat profile for straight cutting on angle grinders
• Aluminum oxide abrasive with resinoid bond for durability and consistent cut rate
• 36 grit for aggressive material removal on steel and stainless steel
• Reinforced construction for added wheel integrity at speed
• 10,200 RPM maximum rated speed
• A36 specification designation

Compatibility

Designed for use with angle grinders accepting a 7/8 inch arbor hole and compatible with wheels rated at or below 10,200 RPM. Suitable for cutting steel and stainless steel.

Installation Notes

Installation and use should be performed by qualified tradespeople familiar with angle grinder safety requirements. Always inspect the wheel for cracks or damage before mounting and confirm the grinder's rated RPM does not exceed the wheel's 10,200 RPM maximum. Ensure the guard is properly installed per tool manufacturer specifications before operation. Follow ANSI B7.1 safety standards for the use, care, and protection of abrasive wheels.