Walter Surface Technologies 10P143 14in Cut-off Wheel

Product Description

The WALTER SURFACE TECHNOLOGIES 10P143 is a Type 1 (01/41) resinoid-bonded cut-off wheel designed for high-speed cutting of steel and stainless steel. Built with 30-grit aluminum oxide abrasive in a reinforced construction, this wheel measures 14 inches in diameter with a 3/32-inch thickness and a 1-inch arbor hole. It is rated for a maximum of 4400 RPM, making it suited for use on large angle grinders and stationary cut-off saws in demanding fabrication and maintenance environments. Licensed trades and metal fabrication shops rely on this wheel for straight, controlled cuts in ferrous and non-ferrous applications.

This wheel is intended for cutting steel and stainless steel in industrial and commercial settings. Typical applications include structural steel cutting, pipe cutting, and metal fabrication work where a 14-inch diameter wheel is required. The aluminum oxide grain and resinoid bond combination delivers consistent cut depth and wheel integrity across repeated cuts in heavy-gauge material.

Key Features

• 14-inch diameter Type 1 (01/41) flat cut-off wheel profile
• 30-grit aluminum oxide abrasive for cutting steel and stainless steel
• Reinforced construction with resinoid bond for durability under load
• 4400 maximum RPM rating for large grinders and cut-off saws
• 3/32-inch wheel thickness for narrow kerf cuts
• 1-inch arbor hole for standard spindle fitment

Compatibility

Designed for use on steel and stainless steel applications with large-diameter angle grinders or stationary cut-off saws that accept a 14-inch, 1-inch arbor wheel running at or below 4400 RPM.

Installation Notes

Installation and wheel changes must be performed by a qualified operator following the grinder or saw manufacturer guidelines and applicable ANSI B7.1 safety standards. Always power down and disconnect the tool from its power source before mounting or removing a wheel. Inspect the wheel for cracks or damage before each use and never operate above the rated maximum RPM. Ensure the arbor flange size and machine spindle are compatible before mounting.