Vestil VGLT-16-3F-Y Flexible Stake 36 in Yellow Surface Mount

Product Description

The VESTIL MANUFACTURING VGLT-16-3F-Y is a surface mount flexible safety stake designed for high-traffic areas where repeated vehicle or equipment impact is a real risk. Standing 36 inches tall, the stake is extruded from hollow polycarbonate and measures 3.125 inches wide with a 3.25-inch convex bulge on both sides for visibility. A rugged hinge at the base allows the stake to bend and flex on impact rather than break, absorbing repeated hits. The unit is FAA approved and weighs approximately 3 pounds. Licensed contractors and facility maintenance crews install these stakes in warehouses, parking lots, driveways, and industrial yards.

This flexible stake is suited for both indoor and outdoor use on hard surfaces including concrete, asphalt, and wood. The 8-inch diameter black ABS plastic base mounts flush to any hard surface. It is particularly effective in high-traffic zones where forklifts, carts, or vehicles may make frequent contact with the delineator. The stake accepts up to two optional self-adhesive reflectors, one on each side, to improve low-light or nighttime visibility. Mounting hardware is not included and must be sourced separately based on the substrate.

Key Features

• Flexible polycarbonate construction withstands impacts up to 80 mph and up to 75 hits at 55 mph
• Rugged hinge at base allows stake to bend and return to upright position after impact
• 36-inch height with 3.125-inch width and 3.25-inch convex bulge on both sides for enhanced sideview profile
• 8-inch diameter black ABS plastic base mounts to concrete, asphalt, or wood surfaces
• Accepts up to two optional self-adhesive reflectors for maximum visibility in low-light conditions
• FAA approved and available in high-visibility yellow

Compatibility

Designed for surface mount installation on any hard substrate including concrete, asphalt, and wood. Mounting hardware is not included. Compatible with optional self-adhesive reflectors sold separately.

Installation Notes

Installation is typically performed by facility maintenance personnel or general contractors. Before drilling into the substrate, identify and avoid any embedded conduit, rebar, or utility lines. Select fastener type based on substrate material in accordance with applicable local building guidelines. Mounting hardware is not included with this unit and must be procured separately.