Value Collection ZMSCVB75122 O-ring Dash 122 Viton 50-pack

Product Description

The VALUE COLLECTION ZMSCVB75122 is a Dash 122 Viton fluoroelastomer O-ring sold in a pack of 50. It measures 1.125 inches inside diameter, 1.313 inches outside diameter, and 0.094 inches thick with a round cross section. The compound delivers a Shore A hardness rating of 75, a working temperature range of -15 to 400 degrees F, and demonstrated resistance to petroleum products. Low compression set and low gas permeability make it a reliable static or dynamic seal in hydraulic, pneumatic, and fuel-system applications. Plumbers, HVAC technicians, and industrial maintenance trades install these seals during routine service or equipment rebuilds.

This O-ring is suited for residential and commercial applications where contact with petroleum-based fluids, fuels, or high-temperature media is expected. Typical install scenarios include fuel delivery components, hydraulic fittings, pump housings, and valve bodies operating within the stated temperature envelope. The fluoroelastomer compound also supports vacuum service and environments requiring a wide spectrum of chemical compatibility. Each pack contains 50 O-rings to support shop stock, fleet service, or multi-unit jobs.

Key Features

• Fluoroelastomer (Viton) compound rated -15 to 400 degrees F continuous service
• Shore A hardness of 75 for reliable compression and sealing force
• Low compression set maintains long-term seal integrity under sustained load
• Low gas permeability suitable for vacuum service applications
• Good resistance to petroleum products and a wide range of chemical media
• Pack of 50 units supports bulk service and shop inventory needs

Compatibility

Designed as a standard Dash 122 O-ring replacement for any fitting, valve, pump, or housing that accepts the 1.125 inches ID by 1.313 inches OD by 0.094 inches cross-section dimension in fluoroelastomer compound.

Installation Notes

Installation is performed by qualified trades including HVAC technicians, plumbers, and hydraulic system technicians. Always depressurize and, where applicable, de-energize the system before replacing any seal. Inspect the groove and mating surfaces for wear or damage before installing the new O-ring. Lubricate the O-ring with a compatible fluid or grease approved for use with fluoroelastomer compounds to prevent rolling or tearing during assembly.