Value Collection ZMSCVB75015 Viton O-ring Dash 015 100 Pack

Product Description

The VALUE COLLECTION ZMSCVB75015 is a Dash 015 Viton (fluoroelastomer) O-ring sold in a 100-piece pack. It measures 0.563 inches inside diameter, 0.688 inches outside diameter, and 0.0625 inches thick with a round cross-section. The compound carries a Shore A hardness of 75 and is rated for continuous service from -15 degrees F to 400 degrees F. Fluoroelastomer construction delivers low compression set, low gas permeability, and broad chemical resistance, making it a dependable sealing choice for high-temperature and chemically aggressive environments. Licensed plumbers, HVAC technicians, and industrial maintenance mechanics are the primary installers.

This O-ring fits sealing applications that involve petroleum-based fluids, hydraulic oils, fuels, and many industrial solvents. Its wide temperature range makes it suitable for both low-ambient outdoor service and high-heat fluid circuits. Typical deployment scenarios include pump shaft seals, valve stems, hydraulic fittings, and fuel-system connections in residential, commercial, and light-industrial equipment. The 100-piece package format supports stocking for ongoing service work or production assembly.

Key Features

• Fluoroelastomer (Viton-type) compound rated from -15 degrees F to 400 degrees F
• Shore A hardness of 75 for firm, low-compression-set sealing
• Low gas permeability suits vacuum service applications
• Good resistance to petroleum products, hydraulic fluids, and a wide spectrum of chemicals
• Round cross-section, Dash 015 standard sizing for drop-in replacement use
• Sold in a 100-piece pack to support fleet service and stocking needs

Compatibility

Designed as a standard Dash 015 O-ring replacement for grooves and fittings that accept a 0.563-inch ID, 0.688-inch OD, 0.0625-inch cross-section seal in petroleum-compatible or high-temperature service.

Installation Notes

Power down or depressurize the system and relieve all fluid pressure before removing the old O-ring. Inspect the groove for nicks, burrs, or corrosion that could damage the new seal. Apply a compatible lubricant to the O-ring before installation to ease seating and prevent tearing. This part is not FDA approved and should not be used in potable-water or food-contact applications without verifying suitability with the equipment manufacturer.