Value Collection ZMSCV70360 Viton O-ring Dash 360

Product Description

The VALUE COLLECTION ZMSCV70360 is a Dash 360 Viton fluoroelastomer O-ring designed for static and dynamic sealing applications where elevated temperatures and chemical exposure are a concern. Measuring 5.875 inches inside diameter, 6.25 inches outside diameter, and 0.1875 inches thick, this round cross-section ring delivers reliable sealing in demanding fluid and gas service environments. With a hardness rating of 70 Shore A and a working temperature range of -15 degrees F to 400 degrees F, it suits high-temperature sealing duties that standard nitrile or EPDM rings cannot handle. Licensed plumbers, HVAC technicians, and industrial maintenance professionals regularly specify Viton compounds for petroleum and chemical service.

This O-ring is suited for sealing applications involving petroleum-based fluids, hydraulic oils, and a wide range of industrial chemicals. Its low gas permeability and suitability for vacuum service make it a practical choice in refrigeration, hydraulic, and pneumatic systems. The Dash 360 designation follows the AS568 standard sizing series, allowing straightforward cross-referencing during maintenance and repair. Each package contains 2 rings. Installations may be residential, commercial, or light industrial depending on the equipment served.

Key Features

• Fluoroelastomer (Viton) compound provides good resistance to petroleum products and wide chemical compatibility
• Working temperature range from -15 degrees F to 400 degrees F suits high-heat service environments
• Low compression set maintains long-term sealing integrity under sustained load
• Suitable for vacuum service with low gas permeability
• Round cross-section, AS568 Dash 360 sizing for standard cross-reference
• Hardness rated at 70 Shore A for a firm, durable seal

Compatibility

Designed as a standard AS568 Dash 360 replacement O-ring compatible with petroleum-based fluids and products. Verify groove dimensions against actual equipment specifications before installation.

Installation Notes

O-ring installation should be performed by a qualified technician familiar with the system being serviced. Shut down and depressurize the system fully before removing the old seal. Inspect the groove for nicks, burrs, or debris that could damage the new ring or cause premature failure. Avoid twisting or overstretching the O-ring during installation; use an appropriate O-ring lubricant compatible with Viton and the system fluid.