Value Collection ZMSCV70120 Viton O-ring Dash 120 50-pack

Product Description

The VALUE COLLECTION ZMSCV70120 is a Dash 120 Viton fluoroelastomer O-ring designed for static and dynamic sealing applications in fluid and gas systems. With a 1.0000 inch inside diameter, 1.1880 inch outside diameter, and a 0.0937 inch (3/32 inch) cross section thickness, this O-ring delivers a precise, consistent seal. The fluoroelastomer construction provides a Shore A hardness of 70, low compression set, and a working temperature range of -15 degrees F to 400 degrees F. It ships in a pack of 50 units, making it suitable for stocking and service van inventory.

This O-ring is used across HVAC, plumbing, refrigeration, and general mechanical applications where resistance to petroleum-based fluids, fuels, oils, and high operating temperatures is required. The round cross section seats reliably in standard O-ring grooves. Its low gas permeability also makes it suitable for vacuum service applications. Licensed plumbers, HVAC technicians, and industrial maintenance professionals regularly install this seal type in pump assemblies, valve bodies, fittings, and fluid connectors.

Key Features

• Fluoroelastomer (Viton-type) material with broad chemical compatibility including petroleum products
• Working temperature range from -15 degrees F to 400 degrees F for high-heat environments
• Low compression set for long-term sealing integrity under sustained load
• Low gas permeability makes it suitable for vacuum service applications
• Shore A hardness of 70 (Hard rating) for controlled deflection under pressure
• Pack of 50 units supports bulk stocking and repeat service calls

Compatibility

Designed as a standard Dash 120 O-ring replacement for any groove or fitting that accepts a 1.0000 inch ID by 1.1880 inch OD by 0.0937 inch cross section round O-ring. Compatible with petroleum-based fluid systems. Not FDA approved; not intended for food-contact or pharmaceutical applications.

Installation Notes

O-ring installation should be performed by a qualified technician following system depressurization and fluid isolation. Inspect the mating groove for nicks, burrs, or debris before seating the ring. Avoid rolling or twisting the O-ring during installation to prevent spiral failure. Lubricate with a fluid compatible with fluoroelastomer materials; do not use petroleum-based greases on seals in systems where they may cause swelling or contamination.