Value Collection ZMSCV70024 Viton O-ring Dash 024 50-pack

Product Description

The VALUE COLLECTION ZMSCV70024 is a Dash 024 Viton (fluoroelastomer) O-ring designed for static and dynamic sealing applications in fluid and gas systems. With a 1.125-inch inside diameter, 1.25-inch outside diameter, and a 0.0625-inch thick round cross section, this O-ring fits standard Dash 024 grooves. The fluoroelastomer compound delivers a working temperature range of -15 degrees F to 400 degrees F, low compression set, and low gas permeability. Licensed plumbers, HVAC technicians, and industrial mechanics install these seals where petroleum-based fluid compatibility and high-temperature resistance are required. Each package contains 50 O-rings.

This O-ring is suited for use in HVAC refrigerant circuits, hydraulic systems, fuel handling lines, and pneumatic assemblies where petroleum products, high temperatures, or vacuum service conditions are present. The fluoroelastomer material provides wide-spectrum chemical compatibility, making it a dependable choice for both residential and light commercial service applications. The round cross-section profile seats cleanly in standard Dash 024 O-ring grooves without modification.

Key Features

• Fluoroelastomer (Viton) compound with good resistance to petroleum products and fuels
• Operating range from -15 degrees F to 400 degrees F for high-heat environments
• Low compression set helps maintain sealing force over extended service cycles
• Low gas permeability makes it suitable for vacuum service applications
• Round cross-section profile for consistent seating in standard Dash 024 grooves
• Hardness rated at 70 Shore A for firm, reliable compression seal

Compatibility

Designed as a standard Dash 024 O-ring replacement for any system or assembly that specifies a 1.125-inch ID by 1.25-inch OD by 0.0625-inch thick fluoroelastomer seal. Compatible with petroleum products and fluids per supplier specifications. Not FDA approved.

Installation Notes

Licensed plumbers, HVAC technicians, or hydraulic system mechanics typically install O-rings of this type. Depressurize and isolate the system before removing the old seal, and inspect the groove for damage or debris before seating the new O-ring. Apply a thin film of a compatible lubricant to the O-ring before installation to prevent twisting or cutting during assembly. Follow applicable codes such as the IPC or IFGC for pressure-system seal replacement where required.