Value Collection ZMSCV70010 Viton O-ring 0.25 in Id Pack 100

Product Description

The VALUE COLLECTION ZMSCV70010 is a Dash 010 Viton fluoroelastomer O-ring used to create fluid-tight and gas-tight seals in a wide range of mechanical systems. With a 0.25 inch inside diameter, 0.375 inch outside diameter, and 0.0625 inch thickness, this round cross-section ring is sized to fit Dash 010 standard groove dimensions. The fluoroelastomer compound delivers a Shore A hardness rating of 70, meaning it resists deformation under load while maintaining an effective seal. This O-ring is rated from -15 degrees F to 400 degrees F, making it well suited for high-temperature service environments. Licensed technicians and mechanics across HVAC, plumbing, hydraulics, and industrial equipment maintenance install this part as a sealing element in pumps, valves, fittings, and fluid handling components.

This O-ring is commonly used in applications involving petroleum-based fluids, hydraulic oils, fuels, and chemical media where standard nitrile or EPDM compounds are unsuitable. The fluoroelastomer material provides low gas permeability, making it appropriate for vacuum service and pressurized systems. It is packaged in a quantity of 100 per pack, which suits service shops and technicians who maintain inventory for recurring maintenance calls. It is not FDA approved and is not intended for food-contact applications.

Key Features

• Fluoroelastomer (Viton) construction with broad chemical compatibility including petroleum products
• Rated from -15 degrees F to 400 degrees F for high-temperature service
• Shore A hardness of 70 for a firm, low-compression-set seal
• Low gas permeability suitable for vacuum service applications
• Round cross-section profile per Dash 010 standard sizing
• Sold in a pack of 100 units — practical for shop stock and recurring service work

Compatibility

Compatible with petroleum products and a wide spectrum of chemical media. Designed as a Dash 010 standard O-ring replacement for use in valves, pumps, fittings, and fluid system components requiring a fluoroelastomer seal rated to 400 degrees F.

Installation Notes

Depressurize and isolate any fluid system before removing or installing O-rings. Inspect the groove for scoring, burrs, or contamination that could damage the new seal or cause leakage. Lubricate the O-ring with a compatible fluid or O-ring lubricant before installation to prevent twisting or nicking during assembly. Do not stretch the ring beyond its elastic limit when seating it into the groove.