Value Collection ZMSCH1.6X2.2 O-ring 2.2in Id Nbr 100pk

Product Description

The VALUE COLLECTION ZMSCH1.6X2.2 is a Buna-N nitrile butadiene rubber O-ring designed for sealing applications in fluid and pneumatic systems. It features a 2.2-inch inside diameter, a 5.4-inch outside diameter, and a 1.6-inch cross-section thickness with a round cross-section profile. Rated at 70 Shore A hardness, this O-ring delivers strong resistance to petroleum-based fluids, reliable compression set performance, and solid tear and abrasion resistance. The operating temperature range spans -40 degrees F to 250 degrees F, making it suitable for a broad range of industrial and trade service conditions. Each order ships as a pack of 100 units.

This O-ring is used in plumbing, HVAC, hydraulic, and pneumatic assemblies where sealing against petroleum-based fluids is required. Common install scenarios include pump housings, valve bodies, cylinder heads, and pipe fittings in both residential and light commercial systems. Buna-N is the most widely used O-ring elastomer in trade applications, and this part suits service technicians, pipefitters, and industrial maintenance professionals who need a reliable, standardized seal in quantity.

Key Features

• Buna-N (Nitrile Butadiene Rubber) construction with excellent resistance to petroleum products
• Round cross-section profile for consistent seating and sealing in standard O-ring grooves
• 70 Shore A hardness rating for firm compression set without excessive deformation
• Wide temperature range: -40 degrees F to 250 degrees F
• Meets SAE and MIL-Spec standards
• Sold in a pack of 100 — minimum order quantity of 1 pack

Compatibility

Compatible with petroleum-based fluids and products. Designed as a standard-dimension O-ring for use in valves, pumps, cylinders, and fittings that accept a 2.2-inch ID round cross-section seal. Not FDA approved. Store away from direct sunlight, motors, and electrical equipment that may generate ozone.

Installation Notes

Installation is typically performed by plumbers, pipefitters, HVAC technicians, or industrial maintenance technicians. Shut down system pressure and depressurize all lines before removing or installing any sealing components. Inspect the mating groove for debris, wear, or damage before seating the O-ring. Do not expose the installed O-ring to fluids or environments outside its rated chemical or temperature range.