Value Collection ZMSCE70014 Epdm O-ring Dash 014 100-pack

Product Description

The VALUE COLLECTION ZMSCE70014 is a Dash 014 EPDM O-ring designed for sealing applications that demand reliable performance across a wide temperature range and compatibility with aggressive fluid types. Measuring 0.5 inches inside diameter, 0.625 inches outside diameter, and 0.0625 inches thick, this round cross-section ring carries a hardness rating of 70 Shore A. EPDM construction gives it strong resistance to hot water, steam, and phosphate ester hydraulic fluids, making it a practical choice for mechanical and fluid system maintenance. Each package contains 100 O-rings. Plumbers, HVAC technicians, and industrial service professionals are the typical end users.

This O-ring is suited for use in plumbing systems, HVAC hot-water circuits, steam service connections, and hydraulic systems that use phosphate ester-type fluids such as Skydrol. The Dash 014 designation follows standard AS568 sizing, allowing straightforward cross-referencing when replacing worn or failed seals in existing equipment. Both residential and commercial service applications fall within its intended use range.

Key Features

• EPDM material rated for service from -65 degrees F to 300 degrees F
• Round cross-section, Dash 014 sizing per AS568 standard
• 70 Shore A hardness for positive sealing under compression
• Compatible with hot water, steam, and phosphate ester hydraulic fluids
• Sold in a package of 100 units, minimum order quantity of 1 package
• Black color for visual identification in field service

Compatibility

Compatible with hot water, steam, and phosphate ester type hydraulic fluid systems. Suitable for use in applications where resistance to Skydrol fluids is required. Designed as an OEM-style replacement seal wherever a Dash 014 EPDM O-ring is specified.

Installation Notes

O-ring installation is typically performed by licensed plumbers, HVAC technicians, or qualified mechanical service professionals. Always shut off system pressure and drain or isolate the relevant circuit before removing or installing seals. Inspect the groove and mating surfaces for nicks or contamination before seating the new O-ring. Avoid twisting or rolling the ring during installation; apply a compatible lubricant where permitted by the fluid system.