Value Collection ZBD9500-227 Viton O-ring Dash 227

Product Description

The VALUE COLLECTION ZBD9500-227 is a Dash 227 Viton O-ring with a round cross section, designed for static and dynamic sealing applications across plumbing, HVAC, hydraulic, and fluid-handling systems. It measures 2.13 inches inside diameter, 2.38 inches outside diameter, and 0.125 inches thick. The Viton (FKM) compound delivers reliable chemical resistance and maintains a seal across a wide temperature range, from -15 degrees F to 400 degrees F. A hardness rating of 75 Shore A makes this an appropriate choice for moderate-to-high-pressure sealing environments where dimensional consistency and material durability are required.

This O-ring suits residential and commercial applications where Viton elastomers are specified for fuel, oil, solvent, or high-temperature fluid contact. Common install scenarios include pump housings, valve bodies, compressor ports, refrigerant fittings, and hydraulic cylinder end caps. Technicians working in HVAC refrigeration circuits, hydronic systems, or industrial fluid controls will find the Dash 227 sizing a standard replacement dimension for a wide range of OEM assemblies. Sold individually per package; minimum order quantity is 10 units.

Key Features

• Viton (FKM) material provides strong resistance to fuels, oils, and chemical solvents
• Operating temperature range of -15 degrees F to 400 degrees F suits high-heat applications
• 75 Shore A hardness rated Hard for use in moderate-to-high-pressure assemblies
• Round cross section at 0.125 inches thick ensures consistent groove seating
• Dash 227 standard sizing simplifies cross-referencing and OEM replacement
• Inside diameter 2.13 inches, outside diameter 2.38 inches for precise fit

Compatibility

Designed as a standard Dash 227 O-ring replacement for equipment specifying a Viton FKM elastomer seal with 2.13 inches ID and 2.38 inches OD dimensions in round cross-section groove configurations.

Installation Notes

O-rings of this type are installed by licensed plumbers, HVAC technicians, and hydraulic system mechanics. Always depressurize and drain the system, and shut off all fluid supply before replacing an O-ring. Inspect the groove and mating surfaces for nicks or corrosion before seating the new ring. Apply a compatible lubricant to the O-ring during assembly to prevent tearing and ensure even seating — avoid petroleum-based lubricants with Viton unless verified compatible with the fluid media in the system.