Value Collection ZBD9500-127 Viton O-ring Dash 127

Product Description

The VALUE COLLECTION ZBD9500-127 is a Dash 127 Viton O-ring designed for static and dynamic sealing applications in fluid and pneumatic systems. Viton (fluoroelastomer) material provides broad chemical resistance and handles a wide service temperature range of -15 degrees F to 400 degrees F, making it a reliable choice in demanding environments where standard nitrile seals fall short. The round cross-section profile seats consistently in standard O-ring grooves, and the 75 Shore A hardness rating delivers firm sealing under pressure. Plumbers, HVAC technicians, and industrial maintenance professionals install these seals routinely during pump, valve, and fitting service.

This O-ring is suited for use in residential and light commercial HVAC equipment, plumbing valves, hydraulic fittings, and general fluid-handling assemblies where Viton is specified. Its 1.44-inch inside diameter, 1.63-inch outside diameter, and 0.0937-inch cross-section thickness correspond to the standard Dash 127 sizing, allowing direct substitution wherever a Dash 127 O-ring is called out on a spec sheet or parts list. Sold individually; minimum order quantity is 25 units.

Key Features

• Viton (fluoroelastomer) material for superior chemical and heat resistance
• Service temperature range: -15 degrees F to 400 degrees F
• 75 Shore A hardness — firm, consistent seal under load
• Round cross-section for reliable groove seating
• Standard Dash 127 designation for straightforward cross-referencing
• Minimum order quantity of 25 units for service-stock replenishment

Compatibility

Designed as a standard Dash 127 O-ring replacement for any application specifying a 1.44-inch ID Viton O-ring with a 0.0937-inch cross section.

Installation Notes

Shut off fluid supply and relieve system pressure completely before removing any fitting, valve, or pump component that retains this seal. Inspect the groove and mating surface for nicks or corrosion before installing a new O-ring. A light film of compatible lubricant aids installation and prevents pinching during assembly. This part is not FDA approved and should not be used in food-contact or potable-water service without confirming regulatory requirements with the authority having jurisdiction.